Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

Guide 26914 en Samsung Galaxy S Display Assembly Replacement Samsung Galaxy S Display Assembly Replacement Replace the Display Assembly in your Samsung Galaxy S Written By Sam Lionheart INTRODUCTION Use this guide to replace the display assembly which inc

Samsung Galaxy S Display Assembly Replacement Samsung Galaxy S Display Assembly Replacement Replace the Display Assembly in your Samsung Galaxy S Written By Sam Lionheart INTRODUCTION Use this guide to replace the display assembly which includes the front glass digitizer and home button cable TOOLS Plastic Opening Tools Phillips Screwdriver iFixit Opening Picks set of iOpener Spudger PARTS Samsung Galaxy S Display Assembly LCD Digitizer Front Panel ? iFixit ?? CC BY-NC-SA www iFixit com Page of CSamsung Galaxy S Display Assembly Replacement Step ?? Rear Case Insert a ?ngernail or plastic opening tool into the divot to the left of the rear- facing camera Gently pry and twist the exible rear cover o ? the back of the phone Step ?? Battery Insert a ?ngernail or plastic opening tool into the recess in the bottom right corner of the battery and lift upward Remove the battery away from the phone ? iFixit ?? CC BY-NC-SA www iFixit com Page of CSamsung Galaxy S Display Assembly Replacement Step ?? microSD Card Using a ?ngertip pull the microSD card straight down out of its slot Remove the microSD card from the phone Step ?? SIM Card Repeat the above procedure to remove the SIM card ? iFixit ?? CC BY-NC-SA www iFixit com Page of CSamsung Galaxy S Display Assembly Replacement Step ?? Display Assembly Use a plastic opening tool to pry up the plastic midframe connector panel Remove the connector panel with a pair of tweezers There should be enough adhesive to readhere the panel upon reassembly otherwise use a small amount of double-stick tape Step Use the sharp tip of a spudger to pry the home button cable connector straight up o ? its socket ? iFixit ?? CC BY-NC-SA www iFixit com Page of CSamsung Galaxy S Display Assembly Replacement Step In the following steps you will be using an iOpener to warm the adhesive a ?xing the display assembly to the rest of the phone This will allow for a safer easier screen removal For proper iOpener use follow our iOpener heating guide make sure to pay attention to all warnings Place a heated iOpener on the left side of the phone for at least seconds Reheat the iOpener and place it on the right half of the phone ? iFixit ?? CC BY-NC-SA www iFixit com Page of CSamsung Galaxy S Display Assembly Replacement Step In the following steps you will be using an opening pick to separate the adhesive securing the front panel glass Only pry where directed If you experience resistance stop sliding the opening pick and reapply heat Insert the edge of an opening pick underneath the bottom right side of the front glass Step Slide the opening pick up along the right side of the display ? iFixit ?? CC BY-NC-SA www iFixit com Page of CSamsung Galaxy S Display Assembly Replacement Step Carefully slide the pick around the corner stopping before the speaker grille at the top of the phone Step