Remerciez-le!

Remerciez @Admin pour avoir partagé cet document gratuitement, de la manière la plus simple, en partageant sur les réseaux sociaux.

D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright ©

D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 1 Cisco TelePresence SX80 Physical interface guide for Cisco TelePresence SX80 Contents Introduction Connecting to the codec The physical interface Socket details Contact us D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 2 Cisco TelePresence SX80 Physical Interface Guide Table of contents Introduction. ............................................................................ 3 User documentation................................................................. 4 Connecting to the codec........................................................ 5 Connect to LAN, microphones, loudspeakers, Touch 10, displays and power. .................................................................. 6 Connect a PC (optional). ........................................................... 7 About cameras......................................................................... 8 Connecting Cisco TelePresence SpeakerTrack 60.................. 9 Connecting Cisco TelePresence Precision 60....................... 10 Connecting Cisco TelePresence PrecisionHD 1080p 4xS2.... 11 The physical interface. .......................................................... 12 The front panel. ....................................................................... 13 The rear panel—overview. ....................................................... 14 Socket details....................................................................... 15 Audio details........................................................................... 16 GPIO details............................................................................ 17 Intellectual property rights...................................................... 18 Cisco contacts. ..................................................................... 18 Thank you for choosing Cisco! Your Cisco product has been designed to give you many years of safe, reliable operation. Our main objective with this guide is to address your goals and needs. Please let us know how well we succeeded! May we recommend that you visit the Cisco web site regularly for updated versions of this guide. The user documentation can be found on ► http://www.cisco.com/go/telepresence/docs How to use this guide The top menu bar and the entries in the Table of contents are all hyperlinks. You can click on them to go to the topic. Contents Introduction Connecting to the codec The physical interface Socket details Contact us Contents D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 3 Cisco TelePresence SX80 Physical Interface Guide Chapter 1 Introduction Contents Introduction Connecting to the codec The physical interface Socket details Contact us Introduction D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 4 Cisco TelePresence SX80 Physical Interface Guide This document describes the physical interface of the following codec: • Cisco TelePresence SX80 User documentation The user documentation for the Cisco TelePresence systems running the TC software includes several guides suitable for various user groups. • Installation guide: How to install the product • Getting started guide: Initial configurations required to get the system up and running • Administering TC Endpoints on CUCM: Tasks to perform to start using the product with the Cisco Unified Communications Manager (CUCM) • Administrator guide (this guide): Information required to administer your product • Quick reference guides: How to use the product • User guides: How to use the product • API reference guide: How to use the Application Programmer Interface (API), and reference guide for the command line commands • Video conferencing room primer: General guidelines for room design and best practice • Video conference room acoustics guidelines: Things to do to improve the perceived audio quality • Software release notes • Regulatory compliance and safety information guide • Legal & license information Downloading the user documentation We recommend you visit the Cisco web site regularly for updated versions of the user documentation. Go to: ► http://www.cisco.com/go/sx-docs Contents Introduction Connecting to the codec The physical interface Socket details Contact us Introduction D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 5 Cisco TelePresence SX80 Physical Interface Guide Chapter 2 Connecting to the codec Contents Introduction Connecting to the codec The physical interface Socket details Contact us Connecting to the codec D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 6 Cisco TelePresence SX80 Physical Interface Guide Connect to LAN, microphones, loudspeakers, Touch 10, displays and power Displays, max 3 (2 HDMI, 1 DVI-I) Loudspeakers, mono or stereo (Euroblock, 3.5 mm) Use speakers with amplifiers. The speaker/amplifier should have balanced input to avoid ground loop noise. LAN (RJ-45) Always use the 1st Ethernet port for LAN, as outlined. Microphones, max 8 (Euroblock, 3.5 mm) If your microphone cable has 3 pins, use , and ground ( ) and leave the mute pin ( ) unused. Make sure all units are switched off when connecting or disconnecting cables. Touch 10 control panel (RJ-45) Insert the provided PoE injector between Touch 10 and the codec’s 2nd or 3rd Ethernet port2. Power (100-240 VAC, 50/60 Hz) AP SWITCH PoE injector 1 The audio line outputs may be configured to be used for loudspeakers. 2 The Ethernet connector is behind the lid at the rear of Touch 10. The Ethernet cable between Touch 10 and the PoE injector must be PoE rated (provided). The Ethernet cable between the PoE injector and the codec is not required to be PoE rated (not provided). Power (100-240 VAC, 50/60 Hz) Always use the provided power cable. The codec inlet or the wall socket outlet must be easily accessible after installation. Audio Line level outputs1 Contents Introduction Connecting to the codec The physical interface Socket details Contact us Connecting to the codec D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 7 Cisco TelePresence SX80 Physical Interface Guide Connect a PC (optional) A PC can be connected to the codec to enable sharing of content locally or with conference participants. Cisco offers a PC presentation cable that connects the codec's DVI-I input and Audio line in port (Euroblock), to the PC's VGA and mini jack connectors. Alternatively, you can use a standard HDMI cable (not included). PC, max 2 (DVI-I/Euroblock or HDMI) Contents Introduction Connecting to the codec The physical interface Socket details Contact us Connecting to the codec D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 8 Cisco TelePresence SX80 Physical Interface Guide About cameras The codec has three HDMI camera inputs, and can therefore support up to three cameras. Cisco provides the following cameras: Cisco TelePresence SpeakerTrack 60 is based on two Cisco TelePresence Precision 60 cameras and a microphone panel for advanced speaker tracking. Cisco TelePresence Precision 60 is a full HD camera with 1080p60 resolution, 20x total zoom, and wide angle view. Cisco TelePresence PrecisionHD 1080p 4xS2 is a full HD camera with 1080p60 resolution and 4x optical zoom. You can use any combination of these cameras, as long as the maximum number of cameras does not exceed three4. See how to connect the cameras on the following pages. For more details about the Cisco cameras, refer to camera guides that are available at ► http://www.cisco.com/go/camera-docs 4 Note that Cisco TelePresence SpeakerTrack 60 consists of two cameras. Contents Introduction Connecting to the codec The physical interface Socket details Contact us Connecting to the codec D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 9 Cisco TelePresence SX80 Physical Interface Guide Connecting Cisco TelePresence SpeakerTrack 60 Connect the two cameras in the SpeakerTrack 60 assembly to the codec’s 1st and 2nd camera inputs (HDMI). Also connect SpeakerTrack 60 to the codec’s 2nd or 3rd Ethernet port, and to power. 1 Refer to the installation guide that comes with SpeakerTrack 60 for further information about camera assembly and cabling. Tip! Should you for any reason run out of Ethernet ports, just connect a switch to the codec’s 2nd or 3rd Ethernet port. Never connect the switch to the 1st Ethernet port. This is reserved for LAN connection only. Power (100-240 VAC, 50/60 Hz) Power adapter Always use the provided power cable and adapter (12 VDC, minimum 6.5 A). 1 Note that the camera surface is hot when the camera is in operation. Contents Introduction Connecting to the codec The physical interface Socket details Contact us Connecting to the codec D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 10 Cisco TelePresence SX80 Physical Interface Guide Power (100-240 VAC, 50/60 Hz) Power adapter Always use the provided power cable and adapter (12 VDC, minimum 3 A). Connecting Cisco TelePresence Precision 60 Connect the camera to one of the codec’s camera inputs (HDMI). Cisco recommends using the 1st camera input for the main camera. Also connect the camera to the codec’s 2nd or 3rd Ethernet port, and to power. 1 Tip! Should you for any reason run out of Ethernet ports, just connect a switch to the codec’s 2nd or 3rd Ethernet port. Never connect the switch to the 1st Ethernet port. This is reserved for LAN connection only. 1 Note that the camera surface is hot when the camera is in operation. Contents Introduction Connecting to the codec The physical interface Socket details Contact us Connecting to the codec D15121.01 SX80 Physical Interface Guide, JUNE 2014. www.cisco.com — Copyright © 2014 Cisco Systems, Inc. All rights reserved. 11 Cisco TelePresence SX80 Physical Interface Guide Connecting Cisco TelePresence PrecisionHD 1080p 4xS2 Connect the camera to one of the codec’s camera inputs (HDMI). Cisco recommends using uploads/S4/ sx-80-guide.pdf